7
Programme overview also see Page 5
Sort the laundry according to type of textile and fabric. Fabrics must be suitable for tumble drying.
After drying...
ciron laundry lightly iron laundry @cdo not iron laundry cmangle laundry
PROGRAMMES TEXTILE TYPE AND INFORMATION
** Cottons
max. 7 kg
Hard-wearing fabrics, boil-resistant fabrics made of cotton or linen.
** Easy-Care
max. 3.5 kg
Non-iron laundry made of synthetic fibres and blended fabric, easy-care cotton.
Iron Dry
c÷@c
Fabrics suitable for ironing (iron fabrics in order to avoid creasing).
Cupboard Dry
@
Single-layer fabrics.
*Cupboard Dry Extra
@
Fabrics made of thick, multilayered items of clothing.
Warm 20’
max. 3 kg
All types of fabric; time programme.
Suitable for pre-dried or slightly damp laundry and for drying off multi-layered, thick laundry.
Only dry wool, sports shoes and soft toys with the basket for woollens aOptional Accessories, page 9.
In the time programme, the laundry's residual moisture is not automatically detected. If the laundry is still too damp
after the drying programme, repeat the programme.
Outdoor
max. 1.5 kg
Fabrics with membrane coating, water-repellent fabrics, functional clothing, fleece fabrics (dry jackets/trousers with
removable internal lining separately)
Rapid 40’
max. 2 kg
Laundry made of synthetic fibres, cotton or blended fabrics (for example) that needs to be dried quickly. The values may
differ from the those specified depending on the type of fabric, mixture of laundry to be dried, residual moisture in the
fabric and loading capacity.
*for Cottons and Easy-Care programmes only
**Dryness levels can be selected individually aCupboard Dry Extra, Cupboard Dry and Iron Dry (depending on the model).
Degree of dryness can be finely adjusted; multi-layered textiles require a longer drying time than single-layered items of clothing. Recommendation: Dry separately.
9704 / 9001289276
*1289276*
Siemens Electrogeräte GmbH
Carl-Wery-Str. 34
81739 München/Deutschland
WT44E100IN
Manufactured by BSH Hausgeräte GmbH under Trademark License of Siemens AG
8
Installation
– Delivery specification: dryer, instructions for installation and use, woollens basket
(depending on model).
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
Setting up the dryer
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean, level
and solid surface.
– Keep the cooling grille at the front of the dryer
unobstructed.
– Keep the area around the dryer clean.
– Make the dryer level using the threaded feet
and a spirit level.
Do not remove the threaded feet under any
circumstances.
Mains connection see safety instructions a Page 11.
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate (a Page 9) must correspond.
– The connected load and necessary fuse protection are specified on the rating plate.
Frost protection / Transport
Preparation
1. Empty the condensation container a page 4.
2. Select any programme using the programme selector.
3. Press the Start/Pause button a condensation is pumped into the container.
4. Wait 5 min., and then empty the condensation container again.
5. Turn the programme selector to Off.
1.
Take all accessory parts
out of the drum.
The drum must be empty.
Make sure that the air
inlet remains unobstructed
Clean and level
2.
Do not operate the dryer if
there is a danger of frost.
Do not set up the dryer behind a door or sliding
door as this may obstruct or prevent the dryer door
from opening. This will prevent a potentially fatal
danger to children from locking themselves in.
To Next Page
Loading...
