en Information on the display
44
Y Information on the display
Information on the display
--------
Note:
If you cannot rectify the fault yourself by turning the appliance off and then on again,
please contact our after-sales service.~ Page 51
Faults Cause/remedy
ð on the display and
drying has stopped.
■ Empty the condensation container and reinsert it.~ Page 31
Press inicio/pausa+carga (start/pause) Ü.
■ Once you have installed the optional drain hose*, make sure that it:
Is correctly connected ~ Page 39
Is free of kinks
Is not blocked or clogged, e.g. with deposits
ñ on the display. Remove the fluff.~ Page 32
Press inicio/pausa+carga (start/pause) Ü.
é on the display. Not a fault. The heat exchanger is being cleaned automatically. Do not pull out
the condensation container while this is displayed.
ò on the display Pour distilled water into the refresher tank. ~ Page 37
Press inicio/pausa+carga (start/pause) Ü.
The display goes out and
inicio/pausa+carga
(start/pause) Ü
flashes.
Not a fault. Energy saving mode is active .
* Depending on how the appliance is equipped or the available accessory
To Next Page