operation en
31
13.8 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page29
▶ Press Start/Nachlegen.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
13.9 Changing the activated
programme end time
You can repeatedly change the set
and activated programme end time
before starting the programme.
Requirements
¡ The programme is set.
→"Setting a programme", Page29
¡ The programme end time is set
and activated.
→"Buttons", Page23
1. Press Start/Nachlegen.
The activated programme end time
is paused.
2. Press Fertig in until the display
shows the required programme
end time.
3. Press Start/Nachlegen.
The changed programme end time
is activated.
13.10 Soaking laundry
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press Start/
Nachlegen.
3. To resume the programme, after
the desired soaking time, press
Start/Nachlegen.
13.11 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
1. Press Start/Nachlegen.
The appliance pauses.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page22
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press Start/Nachlegen.
13.12 Cancelling the pro-
gramme
1. Press Start/Nachlegen.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Spülen programme.
– If the water level is high, start
the Schleudern programme or
select a suitable programme for
draining.
→"Programmes", Page24
3. Remove the laundry.
→"Unloading the laundry",
Page32
To Next Page
Loading...
