Siemens WU14UT61ES - Before Using for the First Time; Starting an Empty Washing

first time en
19
first time
6 Before using for the
first time
first time
Prepare the appliance for use.
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
1. Turn the programme selector to
limp. tambor .
2. Close the door.
3. Pull out the detergent drawer.
4. Pour approx. 1 litre of tap water
into compartment II.
5. Pour standard washing powder
into compartmentII.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
6. Push in the detergent drawer.
7. Press inicio/pausa+carga (Start/
Reload+Pause) to start the pro-
gramme.
a The display shows the remaining
programme duration.
a After the programme has ended,
the display shows: End .
8. Start the first wash cycle or set the
programme selector to to
switch off the appliance.
→"Basic operation", Page28