To Next PageTo Next Page
Need help?Do you have a question about the Sienna Counterweight easel and is the answer not in the manual?
General| Brand | Sienna |
|---|---|
| Model | Counterweight easel |
| Category | Indoor Furnishing |
| Language | English |
Assemble the base using sides, front cross support, and rear support with connector bolts. Attach casters with washers to the front and rear.
Connect the easel assembly to the front cross support and attach back supports and cross support to the base using short connector bolts.
Raise easel assembly and connect back supports using angle adjustment knobs with washers for tilt adjustment.
Attach the bottom canvas holder using long connector bolts and slide the top canvas holder and optional lower canvas holder onto the center mast.
Add weights to the weight box, lock the sliding carriage, and occasionally tighten guide cables for the weight box.
Loosen clamping knobs on the bottom canvas holder, adjust carriage height, and retighten knobs.
Loosen angle adjustment knobs, adjust easel to desired angle, and tighten knobs.
Tighten bottom canvas holder knobs, loosen mast adjustment knobs, raise mast, and retighten.
Tighten bottom canvas holder knobs, loosen canvas holder knob, adjust holder height, and retighten.
