WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
OPERATING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance has a burner which must be lighted by hand. When lighting burner follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS;
M Do not try to light any appliance.
M Do not touch any electric switch; do not use any phone in your building.
M Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
M If you cannot reach your gas supplier, call the fire department.
C. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect
the appliance and to replace any part of the control system and any gas control which has been underwater.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above before proceeding.
2. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP! Follow "B" in the safety information above. If
you don't smell gas, go to next step.
3. Check to make sure that the damper is in the open position and that the damper stop is properly installed before
attempting to light the gas log set. Place a lit match on the ember material closest to the gas supply line. Slowly turn on
the gas. If the gas does not light in ten (10) seconds, turn the gas off and wait about one (1) minute before trying again.
TO TURN OFF APPLIANCE
1. Turn the gas supply off. The flame may continue to burn a minute or two, this is normal due to excess gas trapped
within the sand and burner pan which will burn away.
63 Laxalt Dr. Carson City, NV 89706 775-241-2586
www.sierraproductsinc.net
Ver 04/26/16 5 P/N 140032R3
To Previous Page
Loading...