Need help?Do you have a question about the Sierra Digital Mixer and is the answer not in the manual?
Video Input| video input standard | SMPTE 259M |
|---|---|
| video input connector | BNC female |
| video input return loss | >15dB @ 270MHz (75 Ohm referenced) |
| video input range | 200 meters with Belden 8281 or equivalent |
Video Output| video output standard | SMPTE 259M |
|---|---|
| video output connector | BNC female |
| video output jitter | <350 picoseconds peak-to-peak with 10 Hz high pass filter |
| reference-output delay adjustment resolution | 37 nsec. |
| reference-output delay adjustment range | one video frame period |
| video delay | 1.5 microseconds to 1 horizontal line period plus 1.5 microseconds |
Power| power consumption at 5V | <1.5A |
|---|---|
| power consumption at 8V | <0.8A |
| power consumption at -8V | <0.15A |
Operating Environment| operating temperature range | 0 to 50 C, non-condensing |
|---|---|
| operating humidity range | 0 to 95% RH, non-condensing |
Details the rear panel BNC and D-sub connectors for signal and control.
Lists the functions assigned to each position of Switch A (SWA).
Details the 8 individual switches within the S1 package and their functions.
Sets the transition time for dissolves and fades to black.
Sets the video system standard (50Hz or 60Hz).
Sets the module address for the mixer control port.
Configures the electrical interface for the SmartLinx network port (RS232/RS485).
Configures the electrical interface for the rear panel user port (RS232/RS422).
Connects an optional termination resistor for the RS422 receiver.
Describes on-board switches as replacements for SWA/SWB, to be set to '0'.
Lists and describes various control commands (Gaa, Qaa, Saa, Taa, Waa, Xaa) for the serial interface.
To Next Page