SIFANG CSC-196 - Page 5

3.11.IRIG-B (AC) output card (Code A)………………………………………………………….19
3.12.Monomode optical fiber output card (Code H)……………………………………………...20
3.13.Front panel………………………………………………...…………………………………20
4.Engineering application……………………………………………….25
4.1.About the typical time synchronization systems………………………………………………25
4.1.1.Basic time synchronization system ........................................................................................ 25
4.1.2.Master-slave mode time synchronization system ................................................................... 25
4.1.3.Run-standby mode time synchronization time transmission system ...................................... 26
4.2.CSC-196 Configuration scheme………………………………………………………………27
4.2.1.General description of the configuration scheme ................................................................... 27
4.2.2.Software configuration of the input channel .......................................................................... 27
4.2.3.Master-slave mode time synchronization system（single channel GPS） ............................ 28
4.2.4.Master-slave mode time synchronization system (GPS standby each other) ......................... 29
4.2.5.Master-slave mode time synchronization system（GPS/BD standby other each） .............. 31
4.2.6.Run-standby mode time synchronization system （GPS standby each） ............................ 32
4.2.7.Connecting to time synchronization network ......................................................................... 35
4.2.8.Connecting method of client-side equipments ....................................................................... 36
5.Installation, commissioning and operating maintenance at site………37
5.1.Requirement for antenna installation………………………………………………………….37
5.1.1.GPS antenna installation requirement .................................................................................... 37
5.1.2.Requirement for BD antenna installation ............................................................................... 38
5.2.Routine initialization…………………………………………………………………………..38
5.3.Initialization of BD signal receiving card……………………………………………………..39
5.4.Operating maintenance………………………………………………………………………..40
6.Ordering information………………………………………………….45
6.1.Requirement for ordering……………………………………………………………………...45
6.2.Configuration list of single device…………………………………………………………….46
6.3.Available information code for the device…………………………………………………….50
Appendix A Operating instruction of configuration serial port……….51
A.1 Connection of configuration serial port………………………………………………………51
A.2 Definition of configuration serial port wire…………………………………………………..52
A.3 CSC-196 device default configuration………………………………………………………..52
A.4 Serial port configuration order………………………………………………………………..53
A.5 Operating state definition and fault handling method………………………………………...67