9
sigsauer.com
ballistic groups through the normal rangefinder configuration process by turning on the KILO and
holding down the MODE button to enter programming mode.
QuickBOND™ allows you to quickly bond your KILO to a SIERRA riflescope. On the SIERRA riflescope,
insert the batteries and turn on to illumination setting 1. Then turn on the KILO by pressing and
releasing the RANGE button. Press and hold down both the RANGE and MODE buttons for at least
three seconds while looking through the KILO at the display. Once the display in the rangefinder
reads “BOND” then “GOOD” your devices have been bonded (blue LED on the SIERRA should now be
solid blue). Your calculated ballistic hold for any of the 8 ballistic groups or for a custom gun profile
are now actively synced to your SIERRA riflescope.
To Next Page
