46
Q: When using AB External on my KILO I can no longer see the rangender information
on the HUD in the BDX App.
A: If your KILO and a Kestrel are actively paired (sending / receiving information) the BDX App cannot
be connected and paired to your KILO at the same time.
Q: My KILO is set to AB External but isn’t displaying holdover information.
A: To display a complete ballistic solution your KILO must be actively paired with a Kestrel. No
holdover information is displayed unless the Kestrel and KILO are both on and actively paired.
Q: The rangender HUD in the BDX App is sluggish when using my KILO in AB External
mode (Kestrel is not paired to the KILO)
A: AB External mode on your KILO was designed to be used directly with a Kestrel with AB Elite on
board. This communications protocol is relatively slow and does not respond quickly as compared
to using AB Ultralight. AB Ultralight resides on your KILO and is much faster for calculating ballistic
solutions out to 800 yards.
Q: My KILO and Kestrel are paired but I am not getting anything but zero’s for elevation
and wind holds.
A: You need to setup at least one custom bullet prole on your Kestrel. See the Kestrel
instructions for setting up a bullet prole.
To Next Page
Loading...
Need help?
General
