Need help?Do you have a question about the SIGLENT SDM3055 and is the answer not in the manual?
General| Model | SDM3055 |
|---|---|
| Category | Multimeter |
| Resolution | 5 1/2 digits |
| Display | TFT LCD |
| DC Voltage Accuracy | ±(0.015% + 5) |
| AC Voltage Range | 200 mV to 750 V |
| DC Current Range | 200 μA to 10 A |
| AC Current Range | 10 A |
| Resistance Range | 100 MΩ |
| Capacitance Range | 2 nF to 100 mF |
| Capacitance Accuracy | ±(0.5% + 5) |
| Frequency Range | 20 Hz to 1 MHz |
| Frequency Accuracy | 0.01% + 3 digits |
| Interfaces | USB Device, USB Host, LAN |
| Power Supply | 100 V to 240 V AC, 50/60 Hz |
Details on protection limitations for various input terminals to prevent damage.
Highlights key features and capabilities of the SDM3055 digital multimeter.
Steps for inspecting the instrument and accessories upon receipt.
Instructions on adjusting the instrument's handle for stable positioning.
Overview and description of the multimeter's front panel controls and display.
Description of the interfaces and connectors available on the back panel.
Step-by-step guide on how to power on the instrument.
Explanation of the single and dual display interfaces of the multimeter.
Methods for selecting measurement ranges: Auto and Manual modes.
Options for measurement speed: Slow, Middle, and Fast rates.
Procedure for measuring DC voltage up to 1000V.
Procedure for measuring DC current up to 10A.
Procedure for measuring AC voltage up to 750V.
Procedure for measuring AC current up to 10A.
Procedure for measuring resistance using 2-wire and 4-wire methods.
Procedure for measuring capacitance up to 1000μF.
Procedure for measuring frequency and period of signals.
Procedure for testing the continuity of a circuit.
Procedure for testing the forward voltage drop of a diode.
Procedure for measuring temperature using TC and RTD sensors.
Configuration options for measurement settings like AC Filter and Input Impedance.
Enabling and using the dual display for simultaneous measurements.
Accessing system setup, file management, and configuration options.
Parameters for signal acquisition and triggering modes.
Accessing built-in help information and guides.
Utilizing statistical and mathematical functions for measurements.
Viewing measured data in different formats: Number, Bar Meter, Trend Chart, Histogram.
Configuring automatic and single trigger modes for measurements.
Holding a stable reading on the screen for later viewing.
Demonstrates how to use the statistics function during measurements.
Using relative operation to eliminate impedance errors from test leads.
Guide on how to measure dBm values, commonly used in audio signal measurement.
Introduction to measuring decibel (dB) values between two circuits.
How to set and perform limit tests to check if signals are within range.
Procedure for setting up and measuring temperature with a thermocouple.
How to obtain and hold a stable reading on the multimeter's display.
Using the EasySDM software for remote control and operation of the instrument.
Explanation of true RMS AC measurement and its accuracy with different waveforms.
Understanding how crest factor affects measurement accuracy with non-sinusoidal signals.
Analysis of input resistance and capacitance effects on AC voltage measurements.
Using the analog filter to reduce AC component influence in DC measurements.
List of standard accessories included with the multimeter.
Summary of the product warranty terms and conditions.
Guidelines for maintaining and cleaning the instrument and probes.
Contact information for SIGLENT TECHNOLOGIES CO., LTD.
To Next Page
