The ROX 12.1 EVO can connect to external sensors via two different wireless protocols: Bluetooth Low
Energy (BLE) and ANT+. Please note that many sensors offer both protocols. In that case, you only need
to connect ONE of the two channels to receive the sensor’s data. We recommend here to choose the
connection via ANT+.
The following sensors can be connected:
BLE/ANT+:
› Speed sensor
› Cadence sensor
› Combo sensors for speed and cadence
› Powermeter
› Heart rate sensors (e.g. chest strap)
› Radar
› Gearshift
› Shimano (Di2)
› Rotor power
› Remote controls
ANT+: › Smart trainers that support the FE-C protocol
To find out if your sensors support the above protocols, please refer to the sensor manufacturer’s user
manual. How to establish the connection can be found in the
CHAPTER SETTING THE CONNECTION TO
SENSORS.
You can also make all settings conveniently with your smartphone and the SIGMA RIDE app. Connect
your smartphone on which the SIGMA RIDE app is installed with the ROX 12.1 EVO.
From the device settings, add/delete sport profiles or even set the training views of the individual sport
profiles, you can comfortably configure your ROX 12.1 EVO according to your wishes via the RIDE app.
COMMUNICATION WITH EXTERNAL SENSORS
SETTINGS ROX 12.1 EVO
MAKE SETTINGS ON THE SMARTPHONE
MAKE SETTINGS ON THE DEVICE
To Next Page
Loading...
