6
6.3) PLANE MOVEMENTS : The machine is equipped
with two wheels; after unpacking it and removing the
pallet fastenings, it can be carefully set on the floor and
moved to a plane and smooth surface. The belts are in
the box, but not assembled; their transport can be done
by hand.
6.4) LIFTING BY MEANS OF BELTS
The machine can be lifted by means of a couple of strong
belts located at a distance of 80 cm and positioned as
shown in the drawing.
Lifting regulations by means of belts:
• Make sure the means of lifting is suitable for the
charge.
• Make sure the charge is properly hooked.
• Operate when the area is empty.
• Be properly dressed.
6.5) PACKAGING: The machine must be kept in a closed
and covered place, safe from dust and atmospheric
agents, temperatures ranging from –20 and +40°C,
humidity not over 90%. The place must be in safe and
hygienic conditions being used for alimentary purposes.
7.0) ASSEMBLY
The machine with socle must rest on the floor. Two
wheels are fitted with a special locking pedal to keep it
positioned. The machine without socle must rest on a
table or on a strong and stable trestle.
An electric input line must be installed next to the
machine, this line must feature the wire section of at least 1.5 mm
2
, fitted with lockpin and
circuit breaker. Make sure that voltage V and frequency Hz are the ones shown on the
identification plate of the machine.
Note: A differential unit featuring a 0.03A (Ampere) sneak current must be connected
upstream the line.
To Next Page
Loading...