The SignalFire DIN Gateway V2 has the following features:
- RS485 connection to Modbus master device
- Wide range DC power input. 6 to 36VDC
- 2 digital outputs (open collector), 2 digital inputs, and 3 analog inputs
- DIN rail mount
- Collects and caches Modbus data from all SignalFire remote nodes
- Provides configuration and status registers for remote configuration and status monitoring
- RP-SMA antenna port for connection to external 900MHz antenna
- Stores up to 4700 register values from any combination of remote nodes
- Supports transparent Modbus mode
- Internal Remote Shut Down (RSD) logic control option
- Slave register re-mapping
- Remote configuration of SignalFire devices
- Remote sensor configuration (PACTware and RadarMaster)
- Radio is FCC and IC approved
- AES 128bit Encryption
- Class 1 Division 2 Area certification pending
To Next Page
Need help?
General
