Signature Kitchen Suite SKSPH4802S

Other manuals for Signature Kitchen Suite SKSPH4802S

Questions and Answers

T
timothyhamiltonAug 10, 2025
Why is my Signature Kitchen Suite Ventilation Hood not venting out properly?
- J
  Jean SpencerAug 10, 2025
  Several factors can cause your Signature Kitchen Suite Ventilation Hood to vent improperly. The hood might be too high above the cooktop; in this case, adjust the distance to between 26" and 36". Wind from open windows or doors could interfere; close them to eliminate the wind flow. There might be a blockage in the duct opening or duct work, so clear any obstructions. The duct opening's direction could be against the wind; adjust its direction. Finally, incorrect ducting size can be a factor; change the ducting to the correct size.
D
Dennis AllenAug 14, 2025
What to do if Signature Kitchen Suite Ventilation Hood doesn't work after installation?
- C
  Courtney PruittAug 15, 2025
  If your Signature Kitchen Suite Ventilation Hood doesn't work after installation, first ensure that the circuit breaker and the unit's power are turned ON. Also, check that the power cord is properly connected to the unit.
K
Kenneth HillAug 20, 2025
Why is my Signature Kitchen Suite Ventilation Hood vibrating?
- J
  Jeremy KellyAug 20, 2025
  If your Signature Kitchen Suite Ventilation Hood is vibrating, check the following: Ensure the blower is securely in place by tightening the screws. If the blower wheel is damaged, call for service. Also, verify the hood is properly installed.
M
Michelle DelgadoAug 25, 2025
Why do the speed levels of the blower sound the same on my Signature Kitchen Suite Ventilation Hood?
- M
  Mr. Jake DavisAug 26, 2025
  If the blower speed levels on your Signature Kitchen Suite Ventilation Hood sound the same, it might be due to incorrect ducting size. Change the ducting to at least 8" round or 3-1/4" x 10" rectangular for a single blower, or 10" round for a dual blower.
M
Madison EvansAug 30, 2025
What to do if metal filter is vibrating in Signature Kitchen Suite Ventilation Hood?
- C
  connermatthewAug 30, 2025
  If the metal filter in your Signature Kitchen Suite Ventilation Hood is vibrating, it might be loose. Try changing the metal filter. Alternatively, the spring clip might be broken, in which case you should change the spring clip.
K
Karen ParkerSep 3, 2025
What to do if lights work, but blower is not turning on Signature Kitchen Suite Ventilation Hood?
- N
  nperezSep 3, 2025
  If the lights on your Signature Kitchen Suite Ventilation Hood are working but the blower isn't turning, the blower will function properly after the thermally protected system cools down.