11
Timer display
Using your Induction Hob
To Start Cooking
After power on, the buzzer beeps once, all the indicators light up for 1
second then go out, indicating that the hob has entered the state of
standby mode.
1. Touch the ON/OFF switch, all the indicators
show ‘—’.
2. Place a suitable pan on the cooking zone
that you wish to use. Make sure the bottom
of the pan and the surface of the cooking
zone is clean and dry.
3. Touching the heating zone selection
control, and an indicator next to the key
will flash.
4. Select a heat setting by touching the
‘slider’ control. If you don’t choose a heat
setting within 1 minute, the induction hob
will automatically switch off. You will need
to start again at step 1. You can modify the
heat setting at any time during cooking.
EN-12
To Next Page
Loading...
