Using the Timer
You can use the timer in two different ways:
·You can use it as a minute minder. In this case, the timer will not turn
any cooking zone off when the set time is up.
·You can use it as cut-off timer to turn one or more cooking zones off
after time is up.
·You can set the timer up to 99 minutes.
Using the timer as a Minute Minder
1. Make sure the cooktop is turned on. And zone
selection key is not activated (zone indication ‘-’
is not blinking).
Note: you can set minute minder before or after
cooking zone power setting finished.
2. Touch timer key, ‘10’ will show in the timer display
and ‘0’ will flash.
3. Set the time by touching the ‘slider’ control of
timer.
4. Touch timer control again, then ‘1’ will flash.
5. Set the time by touching the ‘slider’ control .
6. When the timer is set, it will begin to count down
immediately. The display will show the remaining
time.
7. Buzzer will beep for 30 seconds and the timer
indicator shows ‘- -’ when the setting time
finished.
EN-15
To Next Page
Loading...
