EV DC FAST CHARGER MANUAL
SIGNET SYSTEMS Inc.
6
1. INTRODUCTION
Thank you for purchasing this ‘FC50K-CC’ charger. We are sure you will be pleased with its performance and
features. In order to ensure that you obtain the maximum from its operation, please read the following instructions
carefully.
2. APPLICATION
This charger has been designed to only Electric Vehicle Supply Equipment.
It should not be used for charging other types batteries.
3. RECEIVING THE CHARGER
Unpack the charger and examine it for shipping damage. In the event that shipping damage is found, report it as a
claim with the freight company.
Check the charger nameplate against packing lists and purchase orders to verify receipt of proper equipment. If
there are any discrepancies notify the shipper immediately.
All shipments leaving manufacturing have been carefully inspected. If a shipment arrives with the crating or
packing damaged, have the carrier note the condition on the receipt. Check as soon as possible for concealed
damage. If damage has occurred, notify and file a claim with the carrier at once. Do not return the unit to the
shipper. Failure to follow this procedure may result in refusal by the carrier to honor any claims.
4. STORAGE
When the charger is stored prior to being installed and powered up, it must be stored indoors in a clean and dry
environment where the temperatures will remain within the range of -40 °F to 150 °F (-40 °C to 65 °C). The
charger should be stored upright in the shipping carton that it was shipped in. This will help protect the charger
from dust and abrasion. It should be stored in an area where it is not likely to be damaged. Do not stack anything
on top of the charger.
5. MOVING AND TRANSPORT
Care should be taken when lifting units with forklifts or pallet jacks. Forks should extend completely under charger
so as to prevent accidents.
To Next Page