SIGURO SGR-RC-R700B - User Manual

Questions and Answers

A
Amy PerezAug 12, 2025
What to do if a large amount of porridge overflows the edge of my SIGURO Rice Cooker?
- I
  Ian WilliamsAug 12, 2025
  If a large amount of porridge overflows the edge of your SIGURO Rice Cooker, it could be due to several reasons. The motherboard might be damaged, or the main thermostat could be malfunctioning. Also, check the safety valve for any foreign objects and clean it if necessary. Ensure you are not exceeding the maximum line marked on the inner wall of the vessel and that you've added enough water, adjusting the amount as needed. Finally, make sure the lid is properly closed and that you have selected the correct cooking method.
E
Erik DyerAug 18, 2025
Why is the rice undercooked or the cooking time too long in my SIGURO Rice Cooker?
- S
  stephen41Aug 18, 2025
  If the rice is undercooked or the cooking time is too long in your SIGURO Rice Cooker, it could be because you didn't let the rice rest long enough after cooking; allow it to rest and stir to prevent lumps. Ensure the cooking vessel is correctly inserted and level inside the cooker. The cooking vessel might also be deformed.
T
Tonya ThompsonAug 27, 2025
What to do if the display is off and the heating element does not heat up on my SIGURO SGR-RC-R700B?
- A
  Ashley CarrilloAug 27, 2025
  If the display is off and the heating element does not heat up on your SIGURO Rice Cooker, the power cable might not be plugged in. In this case, check the switch, plug, thermal fuse, and power supply. Another potential cause is that the distribution board is disconnected, so check the switch, plug, thermal fuse, and power supply. The power board or the motherboard might be damaged.
A
Alexa MayerSep 2, 2025
Why is the heating element not heating up on my SIGURO Rice Cooker when the display is on?
- H
  hknappSep 2, 2025
  If the display is on but the heating element does not heat up in your SIGURO Rice Cooker, the components of the heating element could be burnt out. Another reason might be that the board’s contacts are disconnected, or the power board is damaged.