Functions (The size will be according to regular practice)
1.Please use on the flat floor and one chair can only bear one person's weight;
2.To avoid using the wrong screws, please fix all the screws before tightening
them;
3.Please don't let the child sit on the chair alone if he is under 5 year-old;
4.Please don't sit on the armrest, in case cause some danger;
5.Do not stand on the chair or use it as a ladder or footsteps;
6.Please don’t put overweight on the chair, or used as trolley;
7.Don’t use sharp or hooked objects to scrape the chair and do not get it close
to the fire;
8.To avoid any harm to your fingers, don’t insert them into the mechanism
while sitting .
Pls read the
Safety
Instructions
below carefully
Installation and commissioning
1、Installation and commissioning.
2、 Check whether the parts are complete and damaged.
3、
Choose a spacious and clean site when assembling. Paper is laid flat on the
ground to prevent parts from colliding with the ground during installation.
4、
Use a soft flannel to remove the dirt on the furniture surface after installation. DO NOT wipe
the furniture with a rag with gravel.
Parts list (The size will be according to regular measurements; One more as a backup)
Notice: Before installa-
tion, pls classify the
screw, measure the
screw lengh for easy
assemble
Notice: Before installation, pls classify the screw, measure the screw lengh for easy assemble
Assemble Introduction (The size will be according to regular measurements ）
Pressing the caster into the
base.
1
Insert the gaslift to the base.
2
Fix the mechanism to the seat
with 4pcs (M6*20) screws
including the shim； Pay
attention to the front and
back direction.
3
4
Fix the back plate to the
seat with 4pcs(M6*35)
screws including the shim.
Put the mechanism into
the gaslift and pull down
the armrest.
5
0 1 2 3 4 5 6 7 8 9 10 cm
Castor:5pcs
Base:1pc
Mechanism:1pc
Backrest:1pc
Seat cushion:1pc
Gas lift:1pc Hex wrench:1pc
User Manual
Backrest screw(M6*35):4+1pcs
Mechanism screw(M6*20):4+1pcs
Armrest can
be rotated
up and down
Backrest tilt tension
adjustment +Tighten
-Loosen
Rotate the handle to adjust
the heightPull out the handle
to adjust the backrest tiltPush
in handle to lock backrest tilt
Lumbar support
depth & height
adjustment
The front
The front
To Previous Page
Loading...
