SIIG RS232 Serial - Windows XP;Server 2003 Driver Installation; Windows 2000 Driver Installation

7
Windows XP (32-/64-bit) / Server 2003
(32-/64-bit)
1. Install the board and boot up Windows.
2. Insert the driver CD. Close the CD autoplay
window if prompted.
3. Select No, not this time, click Next. (Skip
this step if not prompted)
4. Select Install the software automatically
(Recommended), then click Next. (Skip this
step if not prompted)
5. Click Finish. It may take several minutes
for this step to appear. Do not interrupt the
process during this time.
6. Repeat steps 3-5 two times.
7. Restart Windows to complete the
installation.
Windows 2000
1. Install the board and boot up Windows.
2. Insert the driver CD. Close the CD autoplay
window if prompted.
3. At the Found New Hardware Wizard, click
Next.