Silent Venus SVP600 User Manual

Silent Venus SVP600

26 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Silent Venus

SVP600

INSTALLATION & MAITENENCE

This product must be installed in strict accordance with local plumbing

codes. A licensed plumber should install product.

**Visit: www.thesilentvenus.com/our-system for instructional videos**

Questions and Answers:

J
Jessica RobertsAug 4, 2025
How to fix Silent Venus Toilets motor humming but not clearing?
- S
  Stephanie MaloneAug 4, 2025
  If the Silent Venus toilet motor is humming but not clearing, it could be due to a blockage in the unit, possibly from something other than toilet paper or a blocked outlet. First, disconnect the unit from power. Drain the toilet bowl and macerating unit using a siphon. Remove the bowl and check for obstructions. If none are found, remove the unit's lid, then remove the rubber tank and motor as a unit. Disconnect the motor from the tank, loosen the screws on the motor pump, and remove any blockage. Reassemble and reconnect the unit.
J
John OconnorAug 12, 2025
What to do if Silent Venus Toilets motor runs inconsistently?
- D
  Daniel HeathAug 12, 2025
  If the Silent Venus toilet motor runs inconsistently, it might be due to a blockage in the outlet pipe. To resolve this, lift off the lid and check the check valve for any foreign objects. Insert a short length of pipe into the outlet, directing it into a bucket. Then, flush the toilet to see if the unit operates correctly without stopping.
A
Andrea FisherAug 18, 2025
Why Silent Venus SVP600 motor is silent?
- B
  Brian MillerAug 18, 2025
  If your Silent Venus toilet motor is silent, it may be due to a loss of power or a faulty pressure switch. Check if the unit is properly connected to an electrical supply. If it is, the issue may be with the motor itself.

Silent Venus SVP600 Specifications

General

Brand	Silent Venus
Model	SVP600
Category	Toilets
Language	English

Summary

Standard Operation

Electric Requirements

Sanitary Inlets

Sewer Pipe Connection

Pre-Installation Tips

Gravity Fall

Ensures positive gravity fall for all inlet pipe work and horizontal piping for free drainage.

Vertical Installation First

Specifies that any required vertical lift must precede the horizontal pipe run.

Directly Vertical

Advises making vertical lifts direct and limiting initial horizontal runs before a vertical lift.

Pipe Supports

Emphasizes supporting pipe work to prevent blockages from residual solids.

Three Foot Minimum

Requires unit installation at least 3 feet from the soil stack for efficient waste reduction.

Soil Stack Connection

Pipe Work

Discharge

Freezing

Electricity

Easy Access

Bends

Placement Options

Avoid Direct Fall

Avoid Diagonal "Uphill" Pipe Runs

Installation Instructions

Step 1 Place the Toilet

Step 2 Place the Unit

Step 3 Connect Inlets & Outlet

Step 4 Connect the Power Supply

Step 6 Activating the Unit

Guides on removing debris, filling the tank, turning on power, and testing the unit.

Normal Operating Procedures

Troubleshooting Guide

Motor Humming, No Clearing

Addresses blockages causing motor hum without clearing waste from toilet and fittings.

Motor Runs Inconsistently

Silent Motor

Covers issues like loss of power or faulty pressure switch affecting motor operation.

Pressure Switch Not Working

Explains troubleshooting steps for a non-functional pressure switch.

Disassembly for Small Fixes

Impeller Check

Cutter Blades

Reassembly of the Lid