attaching a headboard
First of all decide which end of the bed is to be
used for a headboard, then use scissors to carefully
pierce the fabric where the hole can be felt
underneath the stickers.
Strutted headboards
1. Place the headboard bolt
into the hole and fasten into
place. Lower the headboard
into position before fully
tightening the bolt.
2. Note that headboard heights can be adjusted, by
amending the position of the screws on the back of
the board. There are 5 dierent positions in which
you can adjust the height of your board to allow it
to sit nicely above your mattress.
To Next Page
Loading...