Need help?Do you have a question about the Silentnight divan and is the answer not in the manual?
General| Brand | Silentnight |
|---|---|
| Model | divan |
| Category | Indoor Furnishing |
| Language | English |
List of tools required for divan assembly: mallet, screwdrivers, pliers, scissors. Two people recommended.
Carefully remove packaging, staples, and polythene. Dispose of or recycle packaging responsibly.
Push glides/castors into corner sockets and tap with a wooden/rubber mallet until home.
Screw bolts into threaded holes for legs. For square feet, screw bolts into holes 1 and 2 securely.
Stand divan halves on side and attach U clips as indicated in the diagram to connect them.
Cut temporary restraining straps to release drawers. Avoid pulling straps off as they may tear fabric.
Decide headboard end, pierce fabric where holes are felt, and attach headboard using bolts.
Place headboard bolt into hole, fasten, and lower headboard before fully tightening. Height is adjustable.
Pierce fabric, align headboard and divan holes, thread bolt through, and tighten. Use provided fittings.
Remove polythene and card packaging. Ensure polythene is out of reach of children. Remove packaging staples.
Tools needed: screwdrivers, mallet, bradawl, scissors. Assembly requires minimum two people.
Remove lid ties, take care as lid may open. Hammer castors/glides into corner sockets. Turn base onto castors.
Identify connecting holes on base units. Pierce fabric using bradawl for female/male connectors. Align and connect.
Identify connecting holes on lid inner sides. Pierce fabric, insert female/male connectors, and screw together.
Locate threaded inserts on head end of base unit. Pierce fabric and insert headboard bolt.
To Next Page