Getting Started with Silhouette Curio™
Connecting your Silhouette Curio™
Silhouette Curio™
electronic cutting tool
Silhouette Studio‰
software
replacement
snaps (x4)
8.5” x 6” base with 4
platforms, 1 embossing
mat, & 1 cutting mat
A/C adapter and
power cable
USB cable
blade with
ratchet cap
embossing tip
(fine & wide)
print & emboss
squares (x3)
1
remove tape
1
Check Included Items
The Silhouette Curio™ comes with the items shown in the following list. Check that all the items
have been included before starting. If you are missing any items listed below, please contact
support@silhouetteamerica.com.
Take the Silhouette Curio™ from the box and remove the strips of packing tape as indicated by the
following diagrams. These strips of tape are used to hold the moving parts of the Silhouette in place during
shipment.
remove tape
material
fasteners (x4)
To Next Page
Loading...