55
How to remedy faults easily
What do I do if… It can be due to one of the following causes Remedy
circumstances open by force
2) The residual pressure locking – Release the locking mechanism by
(e.g. by slide control) stuck pushing the slide knob to and fro,
(pressure indicator must be drop-
ped)
– Only reset pressure indicator once
no more steam issues when under
no pressure and open carefully.
Lid handle is damaged Incorrect handling – Replace lid handle with a new
original spare part
Lid handle on the bottom part of Sign of wear and tea – Retighten screw with screwdriver
pressure cooker is loose
Pressure cooker handles are Incorrect handling – It is imperative to replace these
damaged with new original Sicomatic pot
handles. Please contact your
specialist dealer
Lid is difficult to close Rubber gasket for lid does not run – Rub the outer lips of the rubber
round smoothly gasket for lid with a thin layer of
ordinary cooking oil
After closing the slide control Pressure indicator is raised and – Move the slide control to and fro
cannot be moved from setting 0 projects out from the handle; side lightly and without force
to the required pressure control is stuck – Re-open the lid and check the
indication setting 1 or 2 aroma shield cap
– Manual reset of the pressure
indicator
Pressure indicator stays up - Aroma shield cap turned back – Manual reset of the pressure
steam no longer issues indicator
- Pressure indicator stuck. – Should this happen frequently
please contact your specialist
dealer
036_054_Sico t-plus en_231110.qxd:036_054_englisch_04_07.qxd 25.11.2009 8:14 Uhr Seite 49
To Next Page
Loading...