EasyManua.ls Logo

SILLA DUMPER 800 NT SN - User Manual

Default Icon
56 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Manuale di Uso, Manutenzione e Ricambi
Operating, maintenance, spare parts manual
REV. 7 Data 14/01/19

Table of Contents

Questions and Answers

  • R
    Rhonda JacksonAug 16, 2025
    Why is the steering hard on my SILLA DUMPER 800 NT SN Farm Equipment?
    • H
      Holly DavisAug 16, 2025
      If the steering of your SILLA Farm Equipment feels hard, it could be due to several reasons. First, the maximum pressure valve might need adjustment. Second, the suction filter cartridge could be obstructed, requiring cleaning or replacement. Third, the oil level might be insufficient, so you should fill it up. Fourth, there might be oil leakages or air bubbles in the circuit, requiring you to check, tighten fittings, and remove air. Fifth, the suction pipe could be obstructed, needing disassembly and cleaning. Finally, the pump might be worn and require replacement.
  • M
    Mr. Richard LiAug 19, 2025
    What to do if the bucket does not raise on my SILLA DUMPER 800 NT SN Farm Equipment?
    • I
      iandersonAug 19, 2025
      If the bucket on your SILLA Farm Equipment doesn't raise, several issues could be the cause. First, the maximum pressure valve may need adjustment. Second, the suction filter cartridge might be obstructed and needs cleaning or replacement. Third, the oil level in the tank might be insufficient, requiring you to fill it up. Fourth, there could be oil leakages in the circuit, so check and tighten all fittings. Fifth, the suction pipe could be obstructed, so disassemble and clean it. Lastly, the pump might be worn, indicating it needs replacement.
  • K
    Kenneth StokesAug 22, 2025
    Why is the hydraulic oil overheating in my SILLA Farm Equipment?
    • P
      powersedwardAug 22, 2025
      If your SILLA Farm Equipment's hydraulic oil is overheating, there are several potential causes. First, the oil quality might be inadequate, so drain and refill with the oil type specified in the manual. Second, the oil level could be insufficient, requiring a refill. Third, the maximum pressure valves may be jammed, so disassemble and clean them. Fourth, the pumps might be worn, so replace them. Fifth, the dumping control lever may not be returning automatically, so check it. Finally, avoid forcing the control lever when the cylinders are at the end of their stroke and avoid forcing the steering wheel during maximum swerving. In any case, allow the oil to cool and try again.
  • R
    Regina MillerAug 26, 2025
    Why is there insufficient operation of parking brake in SILLA DUMPER 800 NT SN Farm Equipment?
    • Q
      qbassAug 26, 2025
      If the parking brake on your SILLA Farm Equipment isn't working well, it could be due to a few reasons. The hand lever lock or the control rods may need adjustment. Also, the brake drum or brake block lining might be worn, requiring disassembly and replacement.
  • S
    Stephanie VazquezAug 28, 2025
    What to do if there is insufficient operation of hydraulic brakes in SILLA Farm Equipment?
    • N
      Norman BarrettAug 28, 2025
      If the hydraulic brakes on your SILLA Farm Equipment are not operating sufficiently, it could be due to a lack of oil in the circuit or leakages. Fill up the oil and check and tighten all fittings.
  • C
    Christopher HarringtonAug 31, 2025
    Why does the bucket move jerkily on my SILLA DUMPER 800 NT SN?
    • R
      Richard WheelerAug 31, 2025
      If the bucket on your SILLA Farm Equipment moves jerkily, it could be due to air in the hydraulic circuit, so make the air flow out of the pipes and tighten all fittings. It might also be caused by an insufficient oil level in the tank, so fill up the tank with oil. Another cause might be cylinders seizure or breakage of gaskets, so disassemble and replace the worn parts.
  • E
    esandersSep 3, 2025
    Why does the clutch slip during engaging on my SILLA DUMPER 800 NT SN?
    • D
      Daniel SpencerSep 3, 2025
      If the clutch on your SILLA Farm Equipment slips during engaging, the disk thrusting fork may need adjustment.
  • P
    priscilla53Sep 6, 2025
    What to do if the hydraulic brakes get blocked on my SILLA DUMPER 800 NT SN?
    • A
      Amanda StevensonSep 6, 2025
      If the hydraulic brakes on your SILLA Farm Equipment get blocked, it may be due to pump or cylinder jamming. Disassemble and clean the pump to resolve this issue.
  • A
    Alexandra NelsonSep 9, 2025
    What to do if the bucket does not completely raise on my SILLA DUMPER 800 NT SN Farm Equipment?
    • V
      Vincent MyersSep 9, 2025
      If the bucket on your SILLA Farm Equipment does not completely raise, it is likely due to an insufficient oil level in the tank. Fill up the tank with oil to resolve this issue.
  • D
    Daniel SanchezSep 12, 2025
    What to do if the clutch does not disengage on my SILLA Farm Equipment?
    • M
      Margaret ClaytonSep 12, 2025
      If the clutch on your SILLA Farm Equipment does not disengage, it could be due to the screw on the disengaging lever needing adjustment, or oil leakage or insufficient oil in the control device. Adjust the screw and check the oil level, filling it up if necessary.

SILLA DUMPER 800 NT SN Specifications

General IconGeneral
BrandSILLA
ModelDUMPER 800 NT SN
CategoryFarm Equipment
LanguageEnglish