20
Power saving mode:
The device is equipped with an automatic switch-off function to avoid unnecessary energy
consumption.
The device switches to standby mode if the loudspeaker receives no signal or too little signal
within approx. 10 minutes in CD/AUX-IN/USB function.
To resume operation, press the “POWER” button.
Please note: When playing via AUX-In, set the volume on your external device to maximum
and control the playback volume using the volume buttons on this device.
This function is regulated by an EU standard and switching it off does not represent a
technical defect !
If the device is not used for a long period of time, it should be switched off completely or
unplugged to save energy.
Radio operation
Channel search:
˗ Switch on the device and select the radio function using the function selection button.
˗ Manual/Automatic channel search:
Manually:
– press the | or | buttons until the desired frequency appears on the display.
Automatic :
– Press the buttons | or | for more than 1 second. The automatic station search is
started and the device searches for the previous/next station with a sufficient broadcast
signal. The frequency is shown on the display.
– Repeat this process until the desired station is found.
Antenna alignment:
To achieve the best possible reception, pull out the telescopic antenna (13) completely
and align it accordingly.
Mono/stereo reception:
When receiving a stereo station in stereo, the message “ST” appears alternately with the
frequency on the display.
Station storage:
A maximum of 20 station memory locations can be used.
Automatic station storage:
– Press the station memory button “SCAN” for longer than 1 second.
– Automatic station storage begins: All stations with a sufficiently strong signal are
automatically stored one after the other. (P01, P02, ....) The station storage locations are
briefly shown on the display.
– Playback starts automatically from the first saved station.
Manual station storage:
– Tune to the station you want to save.
– Briefly press the “ / REP / MEM” button. The memory location display “P 01” flashes on the
display.
– To save the station in the displayed station memory location, press the “ / REP / MEM”
button again.
– Repeat these steps until you have saved all the stations you want to the memory locations.
To Next Page
Loading...