2
INSTALLATION
The stainless steel exterior of the cabinet has been protected by a plastic covering during manufacturing and shipping. This
covering can be readily stripped before installation. After removing this covering, wash the interior and exterior surfaces using a
warm, mild soapy water solution and a sponge or soft cloth. Rinse afterward with clean water and wipe dry. Do not use
chlorinated cleaners.
Location:
When locating your new Silver King unit, convenience and accessibility are important considerations, but the following installation
guidelines must be observed;
Always avoid locating the unit adjacent to an oven, heating element or hot air source which could adversely affect the
performance of the unit.
The unit must be level.
For proper ventilation, the bottom front of the unit must not be obstructed.
Legs/Casters:
Models without a base come with Legs or Casters. To install them, tilt the unit and thread the Legs or Casters into the four
Rivnuts in the bottom of the cabinet. Make sure that they are installed tightly to prevent future thread wear.
Shelves:
Inside the unit you will find Shelves and a plastic bag containing Shelf Supports. This shelf system allows for easy adjustment to
suit your needs.
Door Adjustment and Swing:
Should the door ever require straightening, loosen the screws on the hinges, square the door with the cabinet and retighten the
screws.
The mounting of the door is easily reversible on single door units should space or convenience require that you do so. Simply remove
the screws holding the hinges, rotate the door 180 degrees and relocate the hinges on the side opposite their original location.
Electrical Connections
Be sure to check the data plate, located on the liner of the cabinet, for required voltage prior to connecting the unit to power. The
specifications on the data plate supersede any future discussion.
Your Silver King refrigerator is equipped with an eight (8) foot power cord. Any attempt to modify the plug will void the warranty,
terminate the manufacturers responsibility, and could result in serious injury.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid
a hazard.”
The circuit must be protected with a 15 or 20 ampere fuse or breaker. The unit must be isolated on a circuit and not plugged into an
extension cord.
Climate Class Rating
Your Silver Freezer has a climate class 4 rating. It is designed for use in areas not exceeding 30°C (86°F).
WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause
cancer, birth defects, or other reproductive harm.
To Next Page
Loading...