Bomi Furniture P/L trading as SilverLynx ABN 99 006 489 541 11-17 Sages Road Glenroy Victoria 3046 Australia
T:+61 3 9359 4000 F:+61 3 9359 4322 E:sales@silverlynx.com.au W:www.silverlynx.com.au
NOTES
• Button head bolts should be regularly inspected and may need to be retightened periodically
• Never drag or move assembled bed as this may damage the bed
CARE & MAINTENANCE
Your SilverLynx product is crafted with care, properly maintained, it will mature over time developing a rich
deep patina enhancing its appearance. To get the best performance from your SilverLynx product, please
follow the simple care instructions listed below.
• Do not use silicone based polishes/cleaners at any time.
• Dust surfaces gently with a feather duster then wipe gently with a slightly damp cloth/chamois.
• Do not allow liquids, damp clothes to remain in contact with lacquered surface for extended periods.
• Never place furniture in close proximity to heating outlets.
• Exposure to direct sunlight will cause colour fading to fabrics, leathers and timber finishes.
• Do not allow solvents, abrasives or heated objects to come in contact with the suite.
• Do not use cordless drivers or power drills to tighten your bed brackets, as over-tightening can cause the
foot end rail to bow.
Contact your retailer or our sales office for further information
*Helpful Tips*
STEP 2 & 3
The button head bolts that connect the Siderails to the Bed Head & Foot can sometimes be tricky to align. If you
are having trouble, try supporting the bottom edge of the Siderail near the bracket and lift it up while you
connect the bolts. This can help line up the holes in both brackets so that the bolt can connect easily.
GENERAL
Make sure not to tighten bolts before attaching all components and making sure they sit square. Once you are
ready, make sure all bolts are snug, then tighten only with ¼ turn of the Allen Key. DO NOT USE powered drills
as over-tightening can cause components to bow.
Never force bolts if you can feel resistance as this can cause the thread to strip. Try to adjust the hole alignment
until your bolt can connect easily by hand.
To Previous Page
Loading...