8
GB
Grill oven (Figure C)
The oven function is particularly suitable for
the gratinating of food.
1. Preheat the grill plates|13.
2. Open the lid|4 of the contact grill up-
wards. Be careful not to raise the lid
any further after it is vertical.
3. Place the food to be grilled on the lower
grill plate.
4. Lift the lid|4 up and pull it forwards and
down, until it is parallel to the lower grill
plate|13.
6.4 Switching off
1. Set both thermostat controls|9 +|15 to
the setting "•".
2. Pull out the mains plug|6.
3. Lift the grilled food off the grill plate|13
using a suitable kitchen utensil. Use e.g.
a spatula made from wood or heat-re-
sistant plastic, but never from metal.
7. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric
shock!
~ Pull the mains plug|6 out of the wall
socket before you clean the contact grill.
~ The device, the power cable and the
mains plug|6 must not be immersed in
water or any other liquids.
DANGER! Risk of injury
through burning!
~ Allow all the parts to cool down before
cleaning.
WARNING! Risk of material damage!
~ Do not use any astringent or abrasive
cleaning agents.
Clean the device after each use and remove
all food residues.
Outer surfaces
• Clean the outer surfaces using a soft,
damp cloth with a mild soap solution.
Grease drip trays
The grease drip trays|
16
may be cleaned
by hand or in a dishwasher.
Grill plates
For purposes of cleaning, remove the grill
plates|
13
from the device after it has cooled
down.
1. Press the grip clamps|
5
to the side and
remove the grill plates|
13
from their
brackets.
2. The grill plates|
13
may be cleaned by
hand or in a dishwasher. Dry them com-
pletely before re-inserting.
3. Place the grill plates into the device and
press them against the grip clamps|
5
until the grill plates click into position.
NOTE:
burnt-on food or fat residue is often
easier to remove if you leave a damp wash-
cloth on the baked-on residue overnight to
soften it.
8. Storage
DANGER for children!
~ Keep the contact grill out of the
reach of children.
• Clean all parts, and allow them to dry
properly before you put the contact grill
away.
•
Figure D:
wind the power cable|
6
around the cable spool|
7
when the de-
vice is upright.
• Select a location where neither high
temperatures nor moisture can affect the
device.
__RP113233_B3.book Seite 8 Donnerstag, 23. April 2015 12:45 12
To Next Page
Loading...
