9 GB
Setting up / Setting-up operation
display
5
will flash rapidly for
approx. 2 seconds to confirm dele-
tion, then go out.
Q
Setting-up operation
Q
Using the radio-controlled
socket (fig. B)
1. Put the radio-controlled socket into
any shuttered socket and connect
the appliance you want to operate.
2. Switch the electrical appliance on.
The radio-controlled socket can
only perform its switching function
when the device to be controlled is
switched on.
ATTENTION! FIRE HAZARD!
Do not attach any appliances which
could cause fires or other damaged
if left unattended when switched
on. The maximum load of every
radio-controlled socket is approx.
3,680 W. Any overload could cause
a risk of fire or damage to the device.
Q
Using the remote-
control (fig. A)
The remote control will control up to 4
remote-controlled sockets (individually,
in groups or simultaneously).
1. Press the desired ON button of the
channel ON/ OFF button
2
(A, B,
C or D) on the remote control of
the device you wish to switch on.
The LED operating status display
5
will light.
2. Press the desired OFF button of the
channel ON / OFF button
2
(A,
B, C or D) on the remote control for
the device you wish to switch off.
The LED operating status display
5
will go out.
3. Confirm the ALL ON / OFF button
3
to switch all remote-controlled
sockets simultaneously.
Q
Trouble-shooting
If the remote control does not
work, please check the follow-
ing points:
Prob-
lem
The operating indica-
tor
1
on the remote
control device illumi-
nates but there is no
reaction
Rem-
edy
· Check that the batteries
still have enough power.
If applicable put in new
batteries.
Prob-
lem
No indicator light
1
on remote control
when pressing “ON”
or “OFF”
Rem-
edy
· Check if the batteries are
inserted correctly.
· Check if the batteries
have proper contact with
the springs, if necessary
adjust.
To Next Page
Loading...
