GB
│
IE
│
7 ■
SFR 3.7 A2
■ To charge the appliance, connect the charger 0
to a mains socket and insert the connecting jack
. into the charging socket on the motor unit .
The indicator light lights up red. When the
appliance is fully charged, the indicator light
lights up green.
NOTE
► Only recharge the batteries when the suction
power of the appliance is noticeably weaker
and the red indicator light is flashing red.
Cleaning and care
DANGER – ELECTRIC SHOCK!
► Prior to cleaning, disconnect the appliance
from the charger 0! Risk of electric shock!
ATTENTION! DAMAGE TO PROPERTY!
► Do not use abrasive or aggressive cleaning
materials. These could damage the surface
of the appliance!
Cleaning the spray bottle
■ Open the spray bottle and empty contents.
Remove the microfibre cover 6.
Wipe the components of the spray bottle with
a damp cloth; if necessary, use a little mild deter-
gent on the cloth.
Washing the microfibre cover
The microfibre cover 6 can be machine-
washed at 60°C. Do not use any fabric
conditioner as this significantly reduces the
cleaning power of the microfibres.
Do not bleach the microfibre cover 6!
Do not wring the microfibre cover 6!
Do not tumble dry the microfibre cover 6!
Do not iron the microfibre cover 6!
Material ingredients:
70% Polyester / 30% Polyamide
Cleaning the appliance
For thorough cleaning, disassemble the appliance:
1) Press the ridged area on the underside of
vacuum attachment and pull the vacuum
attachment from the connecting piece .
Clean the vacuum attachment with a damp
cloth. If required, use some mild detergent on
the cloth.
2) Press the release buttons and at the same
time pull the connecting piece from the
motor unit . Clean the connecting piece
with a damp cloth. If required, use some mild
detergent on the cloth.
3) Remove the dirt container from the motor
unit .
Turn the grey nozzle at the top end of the
dirt container slightly anticlockwise and lift
it off. Now you can pull the grey rod down-
wards out of the dirt container . Rinse the
dirt container with clear water and, if neces-
sary, with a mild detergent.
4) Wipe the motor block off with a damp cloth.
If required, use some mild detergent on the
cloth. Dry the motor unit.
To Next Page
Loading...
