Silvercrest 275652 - Cleaning under Running Water

GB
│
IE
│
13 ■
SRR 3.7 B2
Cleaning under running water
1) Press the release button  so that the cutting unit  pops open.
2) Overstretch the cutting unit  a little so it can be pulled upwards
and off.
3) Hold the cutting unit  under the running water so that the water
flows through the shaving heads from the inside to the outside.
CAUTION! MATERIAL DAMAGE!
Hold only the cutting unit  under running water! The shaver
handset can be damaged irreparably if it is held under running
water.
4) Allow the cutting unit  to dry.
5) Replace the cutting unit  on the shaver. Ensure that it snaps
into place and is seated firmly: