14 GB
Once the connection has been established, the LED will briefly
flash twice every 4 seconds.
If you want to connect a another device to the headphones,
repeat the pairing as described previously.
Please note, your communication device must support Bluetooth
®
Standard 4.0 to use all options.
If you come into range of the paired device with the headphones
switched on, a Bluetooth
®
connection will automatically be
established.
You may need to approve the connection on the communication
device. Please refer to the instructions for use of the communica-
tion device on this topic!
If you leave the range of your communication device with your
headphones, the LED will flash red every 2 seconds. If the connec-
tion is not restored within 5 minutes, the headphones will switch off.
The headphones may be manually switched off by holding the
button for 3 seconds until 4 beep sounds and the LED goes
out.
Connecting the headphones to a second
Bluetooth
®
device
The headphones may be connected to two Bluetooth
®
communication
devices at the same time. If the headphones are already connected to
a device, follow the steps below to connect to the second device:
Activate multipoint mode by briefly pressing the button
8
in
pairing mode until four beeps sound.
Now connect to the second device; please note the above
chapter „Using the headphones“.
To deactivate multipoint mode: disable the Bluetooth
®
connection
on the communication device you wish to remove from multipoint
To Next Page
Loading...
