SHSS 16 A1
■ 8
│
GB
│
IE
│
NI
│
CY
Emptying the dirt container and
cleaning the filter
NOTE
► To achieve the best results, empty the dirt
container 8 and clean the HEPA filter 6
regularly.
1) To open the dirt container 8, remove the hand
element 4 from the hand element recess r.
2) Press the release button
5 and, at the same
time, pull the dirt container 8 forwards and
off.
3) Start by pulling the HEPA filter 6 and then
the coarse filter 7 out of the dirt container 8
(fig. 3). Tap out both parts over a rubbish bin
or similar. If necessary, you can rinse out the
HEPA filter 6
with fresh water. Allow it to air
dry fully afterwards.
Fig. 3
4) Empty the dirt container 8 into the rubbish bin
or similar.
5) First re-insert the coarse filter 7 and then the
dry HEPA filter 6.
6) Replace the dirt container 8 onto the hand
element 4 by first pushing the lower catch on
the hand element 4 into the recess on the dirt
container 8. Then, press the upper part of the
dirt container 8 onto the hand element 4
until the dirt container 8 clicks into place and
sits firmly.
Cleaning the appliance
Wipe the appliance with a damp cloth. For stub-
born dirt, add a little mild detergent to the cloth.
Ensure that the appliance is completely dry before
the next use.
Cleaning the rotary brush
The rotary brush t should be checked regularly
for blockages, and any hairs, threads or dirt should
be removed. Remove the rotary brush t as
follows:
1) Turn the floor nozzle upside down.
2) Push the catch on the cover plate towards the
symbol so that you can remove the cover
plate.
3) Lift out the rotary brush t.
4) To replace the rotary brush t, first push the
broad end onto the drive shaft so that the
rotary brush t hooks into place.
5) Then, push the other end into the mount so
that the rotary brush t sits straight in the floor
nozzle.
6) Replace the cover plate and fasten it firmly
into place by pushing the catch towards the
symbol.
Fig. 4
To Next Page
Loading...
