■ 52
│
GB
│
MT
SAS 7.4 LI B3
4) When you have finished using the appliance, slide the on/off switch 6 to
the rear.
NOTE
► Place the handheld vacuum cleaner in the wall bracket 3 and start the
charging process once the vacuum power has become noticeably weaker
and the charge indicator lamp 7 flashes green.
Cleaning
To achieve the best results, empty the dirt container q and clean the dust filter 0
after every use.
CAUTION! MATERIAL DAMAGE!
► Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
1) To open the dirt container q, press the release button 8 and remove the
dirt container q.
2) Remove the dust filter 0 from the dirt container q.
3) Empty the dirt container q.
4) Pull the dust filter bag 9 with its holder out of the dust filter 0.
5) Rinse the dust filter bag 9 out in cold water and wait until it is completely
dry before reinserting it into the dust filter 0. Do not dry it with hot air.
6) Reinsert the dust filter 0 into the dirt container q. When doing so, ensure
that the dust filter 0 is seated squarely and that the rubber lip seals the dirt
container q.
7) Replace the dirt container q on the motor unit w again:
– Push the plastic tab on the underside of the handheld vacuum cleaner
into the recess on the dirt container q.
– Press the release button 8 and push the dirt container q onto the motor
unit w at the same time.
– Let go of the release button 8 so that the restraint engages in the recess.
The dirt container q is now firmly seated on the motor unit w.
8) Clean the housing and both nozzles with a lightly moistened cloth. For stubborn
soiling use a mild detergent on the cloth.
9) Dry all parts thoroughly before using the appliance again or storing it.
IB_314894_SAS7.4LiB3_LB5.indb 52 04.12.18 11:27
To Next Page
Loading...
