How to fix small ice cubes from my Silvercrest 331074 1907 Ice Maker?
If your Silvercrest Ice Maker is producing small ice cubes, it might be due to poor heat dissipation. Ensure the appliance has about 20 cm of free space on all sides. Also, high water temperature can be a factor; make sure the water used is between 8 and 25°C. Finally, high ambient temperature can cause this issue; ensure the ambient temperature is between 10 and 32°C.
What to do if the 'Add water' lamp lights up on my Silvercrest 331074 1907 Ice Maker?
If the 'Add water' lamp is illuminated on your Silvercrest Ice Maker, it could mean that the water tank doesn't have enough water. Refill the water tank. Another possibility is that the water filter in the tank is blocked. Clear any obstructions from the water filter; you can remove it to clean it if needed. If the pump is defective, contact Customer Service.
Why does the 'Add water' light keep turning on my Silvercrest Ice Maker?
If the 'Add water' lamp is illuminated on your Silvercrest Ice Maker, it indicates one of three possible issues: the water tank may be low and needs refilling as described in the section "Filling the appliance"; the water filter in the tank might be blocked by deposits or objects (clean or remove the filter); or the pump could be defective, in which case you should contact customer service.
Why does the "Add water" light turn on in my Silvercrest Ice Maker?
If the "Add water" lamp lights up on your Silvercrest Ice Maker, it could be due to several reasons. First, ensure that the water tank has enough water. Refill it as described in the manual. Alternatively, the water filter in the tank might be blocked. Remove any obstructions from the water filter. If needed, you can remove the water filter by pulling it upwards. Put it back before using the appliance again. For stubborn blockages, follow the cleaning instructions in the manual. If these steps don't resolve the problem, the pump might be defective, and you should contact Customer Service.
What to do if the "Ice full" lamp is on in my Silvercrest 331074 1907?
If the "Ice full" lamp lights up on your Silvercrest Ice Maker, it indicates that the ice basket is full. Remove some ice cubes to resolve this. If the basket isn't full, the infrared sensors above the ice basket might be dirty. Clean them with a soft cloth. If the problem continues, the infrared sensors may be defective, and you should contact Customer Service.
What to do if the 'Ice full' lamp lights up on a Silvercrest 331074 1907?
If the "Ice full" lamp is lit on your Silvercrest Ice Maker, here's what you should do: * The ice basket is full: Remove some ice cubes from the basket. * The infra-red sensors are dirty: Clean the sensors with a soft cloth. * The infrared sensors are defective: Contact the Customer Service department.
What to do if the Silvercrest Ice Maker is not working?
If your Silvercrest Ice Maker isn't working, first ensure the plug is properly inserted into a working mains power socket. If it still doesn't work, the appliance may be defective, and you should contact Customer Service.
Why is my Silvercrest 331074 1907 Ice Maker not making ice?
If your Silvercrest Ice Maker isn't producing ice cubes, check the following: * Ensure the ambient temperature is no higher than 32°C. * Verify that the water used is between 8 and 25°C. If these are within range, the cooling system may be leaky or blocked, and you should contact customer service.
What to do if both 'Add water' and 'Ice full' lamps light up on my Silvercrest 331074 1907 Ice Maker?
If both the 'Add water' and 'Ice full' lamps are illuminated on your Silvercrest Ice Maker, the ice cube tray in the back might be blocked. Check for any obstructions, like an ice cube, and remove them. Then, unplug the appliance, plug it back in, and restart it.
Why are the ice cubes from my Silvercrest 331074 1907 Ice Maker too small?
If your Silvercrest Ice Maker is producing ice cubes that are too small, ensure proper heat dissipation by setting up the appliance with at least 20 cm of free space on all sides. Also, the water temperature may be too high. Make sure you are using water between 8 and 25°C and that the ambient temperature is between 10 and 32°C.
General| Brand | Silvercrest |
|---|---|
| Model | 331074 1907 |
| Category | Ice Maker |
| Language | English |
To Next Page
