GB
│
IE
│
NI
│
CY
│
7 ■
SHAC 2400 C2
Cool shot function
You can use the cooling level button 5 to produce a cool air flow. The works
with low and high airflows as well as with medium and high heat levels. The low
heat setting has no heat function. If you wish to create a cold air stream, press
and hold the cooling level button 5 . When you no longer need the cold air
stream, release the cooling level button 5 .
Ionisation function
When drying the hair using a hair dryer, the hair takes on a static charge and
begins to „fly“.
The ionisation function ensures that this charging of the hair is neutralised and
cancelled. The hair becomes soft, supple, shiny and easier to style.
Please note, however, that the ionisation function only works optimally if the
attachments (volume diffuser 6/wide styling nozzle 7/narrow styling nozzle 8)
are removed, as an attachment will interfere with the application of ions to the
hair. Therefore, use the hairdryer without attachments for maximum ionisation
effect.
Fitting/removing attachments
■ To fit one of the attachments (wide styling nozzle 7, narrow styling nozzle 8,
volume diffuser 6), push it onto the front of the hairdryer with slight pressure so
that the attachment snaps into place and is evenly seated on the hairdryer.
■ Always wait until an attachment has cooled down before removing it.
Remove the cooled attachment from the hair dryer by pulling it downwards
with a firm motion.
IB_339683_SHAC2400C2_LB6-.indb 7IB_339683_SHAC2400C2_LB6-.indb 7 20.02.2020 09:58:2720.02.2020 09:58:27
To Next Page
Loading...
