8 GB/IE/NI
Safety / Setting up
only be carried out by the service
department or a specialist electrical
workshop.
J Before cleaning always disconnect
the device from the mains supply. In
this case always remove the radio-
controlled electrical outlet socket
from the mains wall socket and
remove all plugs from the device.
J Do not have one radio-controlled
electrical outlet socket inserted
behind the other.
J Do not use any additional child
protection devices for the radio-
controlled sockets. The connection
between the plug and the radio-
controlled socket could be impaired
and risk from overheating then arises.
The radio-controlled sockets already
have a child protection device which
prevents children from putting any
objects into the socket.
J Ensure that the outlet is installed
close to the connected product, is
easily accessible and that the prod-
uct is not operated while covered.
J If the device malfunctions, switch it
off immediately.
J These instructions are a component
of the device. If you pass the device
on to a third party, these instructions
must also be handed on.
Do not switch the wireless sockets
erratically or unattended.
Q
Setting up
Q
Preparing the remote
control (fig. A)
1. Open the battery compartment on
the back of the remote control by
turning the battery cover to the left
with a coin or a screwdriver. Insert
the button cell. Ensure correct
polarity (+ = up).
2. Press one of the ON/OFF buttons
2
or
3
to verify the remote con-
trol is working; if so, the operating
control lamp
1
will light up.
Q
Setting up the remote-
controlled socket
1. Plug the remote-controlled socket
into an earthed household socket.
2. The LED operating status display
5
will now flash slowly for approx.
30 seconds after plugging in.
3. Aim the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
4. With the LED operating status dis-
play
5
flashing, press the desired
ON button of the channel ON /
OFF button
2
(A, B, C or D) on
the remote control. The LED operat-
ing status display
5
will now light
continuously. You can now use the
remote control to switch a connect-
ed device on or off using.
5. Repeat this process with the other
wireless sockets.
To Next Page
Loading...