13 GB/CY
Comb attachment
(mm)
Trim length
(mm)
Trim length with accurate trim adjustment
(mm)
0.8 1.1 1.4 1.7 2.0
3.0 3.8 4.1 4.4 4.7 5.0
6.0 6.8 7.1 7.4 7.7 8.0
9.0 9.8 10.1 10.4 10.7 11.0
12.0 12.8 13.1 13.4 13.7 14.0
20.0 20.8 21.1 21.4 21.7 22.0
30.0 30.8 31.1 31.4 31.7 32.0
Note: Ensure that you move the product away
from the hairline and slowly push it downwards.
Note: The scissors
18
supplied may be used for
additional styling.
Thinning hair
Note: Using this function you can reduce the
volume of the hair by collecting and cutting only
some of it off.
Place the thinning attachment
12
onto the pro-
duct as described in the chapter ”Changing
the attachments.”
Note: The thinning attachment
12
prevents
every hair from being cut.
Trimming beards
Note that the desired trim length can only be
achieved if the product is held perpendicularly
to the skin‘s surface.
Comb the beard using the supplied comb
17
in its direction of growth.
Shorten the beard downwards from the ear to
the chin, one side after the other.
Use the cutting unit
1
without the comb
attachment
11
to trim the beard very short or
to trim a moustache or hairline.
Graduate the desired trim length by rotating
the lower part of the product
5
according to
length position indicator
4
. The trim length
may be set to 5 different levels (0.8 mm /
1.1 mm / 1.4 mm / 1.7 mm / 2.0 mm).
To trim a moustache, firstly comb it straight
downwards. Begin in the centre above the
mouth, then one side and then the other.
Cleaning and care
CAUTION! DANGER TO LIFE BY ELECTRIC
SHOCK! Pull the plug-in mains adapter
7
out
of the mains socket before cleaning the product.
Never touch the plug-in mains adapter
7
with
moist or wet hands, especially when you plug
it into the socket or pull it out of the socket.
Always keep the plug-in mains adapter
7
and
supply cord dry.
CAUTION! RISK OF PROPERTY DA
MAGE!
Do not submerge the product in water or any
other liquid to clean it as the product is not
waterproof. This could damage the live parts
(rechargeable batteries).
Do not use any corrosive or abrasive cleaning
agents.
Clean the housing and the charging base
6
using a damp cloth and a mild detergent.
Switch the product off by sliding the ON / OFF
switch
3b
to the ”0” position.
Disconnect the supply cord from the product
and remove the plug-in mains adapter
7
from
the mains socket.
Remove the comb attachment
11
, the thinning
attachment
12
or the cutting unit
1
from the
product (see Fig. G + H).
To Next Page
Loading...
Need help?
General
