9 GB/CY
damage. Never use a damaged
product.
If liquid gets into the product,
check before using the product
once more.
If you notice that the supply cord,
plug-in mains adapter, housing
or another part has become da-
maged, the product can no lon-
ger be used.
Repairs should only be carried
out by a specialist. Improper re-
pairs may result in considerable
danger to the user. This will also
make any warranty claims void.
Do not use defective attachments
with the product as these could
have sharp corners.
Defective components must al-
ways be replaced with original
spare parts. Only by using origi-
nal spare parts can you ensure
that safety requirements are met.
Connect the plug-in mains
adapter to an outlet which is
well within reach.
Never use the product unsuper-
vised and only use it in acc
ordance
with the information stated on
the type plate.
Connect the supply cord to the
product before inserting the
plug-in mains adapter into the
socket.
The tips of the attachments are
sharp.
Switch off the product before
attaching or switching the at-
tachments, as well as before
cleaning.
Lay the supply cord so nobody
will step on or trip over it.
Do not use the product if you
have an open wound, cut,
sunburn or blister.
Avoid the danger of
damage to property
Electrical products may pose a
hazard to animals. Animals can
also damage the product. Al-
ways keep animals away from
electrical products.
Protect the product from moisture,
drops of water and splashing
water.
Ensure that the supply cord does
not get stuck in cupboard doors
and that it is not pulled over hot
surfaces. This could damage the
supply cord‘s insulation.
Use the original accessories only.
Do not place the product on hot
surfaces, near hot surfaces or
near an open fire.
To prevent impermissible heating
do not cover the plug-in mains
To Next Page
Loading...
Need help?
General
