- 8 -
Synchronising the transmitter and receiver
The transmitter and receiver of this doorbell system can com-
municate with each other on a variety of different frequencies.
Consequently, up to four transmitters can be operated with
one receiver. The precondition for this is that the transmitter and
receiver within a system are working on the same frequency.
For this, you must synchronise the appliances as follows:
Press the synchronisation button on the receiver >
w.
The red signal indicator q now glows.
Now press the bell button >
s on the transmitter.
If the synchronisation has been a success, the receiver notifies
you of the programmed call signal. The appliances terminate
the synchronisation mode and the signal indicator q goes
out. Should the receiver not react as described, repeat the
synchronisation.
The transmitter shows, with a brief glowing of the indica-
tor f when being activated, the transmission of the signal
to the receiver.
LB3C.indb 8LB3C.indb 8 20.07.2010 10:37:28 Uhr20.07.2010 10:37:28 Uhr
To Next Page
Loading...
