- 18 -
Battery operation:
To save energy, the display illumination is deactivated in battery
operation.
1. Press the button
SNOOZE/DISPLAY DIMMER.
The display is illuminated for ca. five seconds.
Projection of the time
For the time display to be well visible on a wall or ceiling, the room must
be darkened.
Important:
The time display projection is created with an LED.
NEVER look directly at the lightbeam. NEVER direct the lightbeam at
other people or animals.
Mains power operation:
1. Press the button
PROJECTION ON/OFF.
The projection lens glows permanently.
2. Swivel the projection lens in the desired direction.
The time is projected onto the selected position. The projection
distance ranges from ca. 0,4 m to 4,0 m
3. Adjust the sharpness of the projection with the slider
FOCUS.
You can turn the projection of the time through ca. 90° with infinite
variability.
4. Turn the adjustment wheel
ROTATE PROJECTION.
You can turn or mirror the projection of the time through 180°.
5. Press the button
PROJECTION REVERSE.
6. To switch the projection off, press the button
PROJECTION ON/OFF once
again. The projection lens extinguishes.
To Next Page
Loading...
