SHC 240 B2■ 10
│
GB
│
IE
│
NI
Curling your hair
Once you have made all settings on the appliance and the Temperature display 7
is permanently lit up (temperature reached):
1) Always use the hair template w to separate the hair strands and prevent the
hair from getting caught in the curling chamber 1.
Make sure that the hair strand is only as thick as the punched hole in the hair
template w.
2) When placing the hair strand into the curling chamber 1, the opening must
be facing towards the head. Hold the appliance around 5 cm from your
scalp. The strand of hair must be inserted straight and taut.
3) Let go of the hair strand and press and hold the Start button u.
The roller 2 starts turning and winding up the strand of hair.
4) As soon as the set number of turns has been reached, the roller 2 stops and
the appliance beeps. You can now stop pressing the Start button u.
The set time starts counting down. As soon as the time has elapsed, you will
hear 3 beeps.
NOTE
► If a strand of hair gets caught in the curl chamber 1, the roller 2 stops,
you will hear 3 beeps and “Er2” appears on the display. Press the Release
button
8 to release the mechanism and pull the hair strand out of the
device. Then press the On/Off button
r and make the desired settings
again to continue curling.
To Next Page
Loading...
