Silvercrest RT2000 - Page 19

21
Gi
the adapter (14) are aligned to the
grooves (13) in the valve.
□ Then slide the corresponding adapter on
the valve until it latches into place.
The RA and RAV adapters are produced to
have a pretension in order to provide a bet-
tert.Ifnecessary,useascrewdriverduring
assembly in order to open the corresponding
adapter a little in the area of the screw.
□ Afterttingtherelevantadapteronthe
valvebody,xtheadapterinplaceusing
the relevant screw and nut supplied (see
Fig. 2, 3).
□ Fixthevalveadapterrmly.
In the case of RAV valves, the plunger exten-
sion(15)mustbetonthevalvepin(seeFig.
2) prior to assembly.
Fit the device on the valve or adapter.
The device latches audibly�