Silvercrest SABD 3.7 LI D4 - Storage; Technical Data; Troubleshooting

SABD 3.7 LI D4 GB
│
IE
│
17 ■
Storage
ATTENTION! PROPERTY DAMAGE!
► Ensure that the appliance is switched off
before putting it away. Otherwise the battery
could be damaged by excessive discharging.
■ Store the cleaned appliance in a clean, dust-free
and dry place.
Troubleshooting
The appliance will not start.
■ The battery is discharged. Recharge the
appliance.
■ The appliance is defective. Contact the
Customer Service department.
The rotary brush z generates loud
noises when turning.
■ The rotary brush z is dirty. Clean the rotary
brush z.
■ The rotary brush z is not inserted correctly.
Check that the rotary brush z is correctly inserted
and correct the installation if necessary.
Technical data
Charger
Input: 100 – 240 V ∼ (alternating
current), 50/60 Hz, 0.3 A
Output: 5.3 V
(DC), 500 mA
Type designation: ZD006C053050EUE
Nominal ambient
temperature (ta) 40 °C
Manufacturer: E-TEK Electronics
Manufactory Co., LTD
Protection type: IP 20 Protected against
ingress of solid foreign
objects with a diameter
of
>
12.5 mm.
symbols used
Protection class II
(double insulation)
Polarity of the barrel plug
v
Efficiency class 5
Cordless sweeper
Input: 5.3 V
500 mA
Battery working
voltage: 3.7 V
Battery: lithium ion battery
1 x 3.7V, 2200mAh
Polarity:
Charging time with
empty battery: 5 hrs.
Operating time with full battery charge (depending
on floor covering): approx. 70 min.