GB
│
IE
│
NI
│
CY
│
7 ■
SAS 7.4 LI B2
Information about the batteries
1) This handheld vacuum cleaner is powered by rechargeable lithium-ion batteries.
2) For care of the batteries, we recommend the following: Once the batteries
have been charged, disconnect the mains adapter from the mains socket.
Do not reconnect the mains adapter with the mains socket until the hand-
held vacuum cleaner’s suction power has noticeably decreased.
Installation of the wall bracket
DANGER – ELECTRIC SHOCK!
► Ensure that there are no power cables or other conduits or pipes in the wall
at the location where you intend to bore the holes for the wall bracket .
Drilling into a current-carrying electric cable can be potentially fatal!
1) Place the barrel plug of the mains adapter into the wall bracket as
shown in the diagram. Secure the barrel plug by turning it.
2) Select a suitable installation location for the wall bracket :
It must be possible to remove the handheld vacuum cleaner easily and there
must be an accessible mains power socket for the mains adapter .
3) Drill two holes about 61 mm apart. Use the wall bracket to mark the holes,
to ensure the correct spacing. The drill holes must be suitable for 5 mm wall
plugs.
4) Push the wall plugs . into the holes and then screw the wall bracket
firmly into place using the screws !.
5) You can place the nozzles on the accessories holder on the side.
6) Connect the mains adapter to a mains power socket.
To Next Page
Loading...
Need help?
General
