Silvercrest SAST 18 A1 Short Manual

■ 12
│
GB
│
IE SAST 18 A1
Operation
ATTENTION!
► The suction opening must always be open and may not be blocked.
Blockages lead to overheating and damage to the motor.
► Use the wet-suction nozzle
5 only at level I (low/wet suction ).
NOTES
► Make certain that the HEPA filter
z is inserted before using the appliance.
► When vacuuming liquid, do not exceed the MAX marking in the dirt
container
i.
► If the motorised brush attachment
6 is blocked so that the brush can no
longer turn, the charge indicator lampw flashes red after approx. 15seconds
of the blockage, the working lightt goes out and the appliance stops
vacuuming. If this happens, remove the blockage as described in the section
“Cleaning the brush attachment”. Slide the On/Off switch
q to the “OFF”
position. To restart the appliance, slide the On/Off switchq to position I
or II.
1) Remove the appliance from the wall bracket
7 or, if you are not using the
wall bracket
7, remove the barrel plug 9 from the socket.
2) If required, place the appropriate nozzle in the suction opening. See section
“Using accessories”.
3) To switch the appliance on, slide the On/Off switch
q forwards into
position I (= low power/wet suction ) or position II (= high power).
The charge indicator lamp w lights up yellow at level I, green at level II.
The working light t lights up.
4) To switch the appliance off, place the On/Off switch
q back to the “OFF”
position. All lamps go out.
NOTE
► After you have vacuumed up liquids, clean the dirt container i
immediately. Otherwise, bacteria or mould will build up inside! Ensure that
the HEPA filter
z is completely dry before using the appliance again.

Silvercrest SAST 18 A1 Specifications

General

Brand	Silvercrest
Model	SAST 18 A1
Category	Vacuum Cleaner
Language	English