49
GB
LED indicators
NOTE: the function indicators can also be combined.
Example: the LED indicator is lit red and flashes in blue, if a Bluetooth
connection is established while charging.
7.1 Establishing a Bluetooth connection
NOTES:
• The identification of the device is "SBLS6A1".
• After turning it on, the device automatically tries to reconnect to
the last paired device or to establish a new connection.
• Please observe that the establishment process of the connection
may vary slightly depending on the device and the software
used.
• The device switches itself off, …
… if no Bluetooth connection is established within 10 minutes or
… if it does not receive a signal for 10 minutes.
• If the device has switched off automatically, first switch it off by
means of the ON/OFF9 switch before being able to switch it
back on again.
• Depending on e.g. the volume, the device may be used for a peri-
od of approx. 10 hours while the Bluetooth connection is estab-
lished.
1. If necessary, remove the plug of the 3.5 mm stereo jack cable10
from the socket AUX8.
2. Switch on the device using the ON/OFF9 switch. The LED3 is
lit green. An acoustic signal sounds. Then the LED3 flashes
blue/red.
LED indicator3Function
LED flashes
blue/red
• Device attempts to make a connection to
the most recently paired device
• Device sends device identification
LED flashes blue Bluetooth connection is established
LED flashes green
Connector of the 3.5 mm stereo jack
cable10 is plugged into the AUX8 jack
socket
LED flashes red The battery must be charged
LED is lit red The battery is being charged
BB58B%OXHWRRWKB6SHDNHUB[:B%ERRN6HLWH'RQQHUVWDJ-XOL
To Next Page
Loading...
Need help?
General
